E-steps calculator

Calibrate your extruder in five minutes: extrude 100 mm, measure what really went in, and get the corrected E-steps or rotation_distance.

Never uploadedMarlin M92Klipper rotation_distanceStep-by-stepInstant

Loading tool…
3dfiles Pro: big files, STEP export, batches.Pro adds files over 100 MB, unlimited STEP export, fit-to-printer cuts, colour 3MF and big batches. Free for 7 days, or a one-off 7-day pass.
See Pro

How to calibrate E-steps

  1. Heat the nozzle to your usual printing temperature – extruding cold filament gives wrong results.
  2. Find the current value: send M503 and look for the M92 … E number (Marlin), or read rotation_distance in printer.cfg (Klipper).
  3. Mark the filament 120 mm above where it enters the extruder.
  4. Send M83 (relative extrusion), then G1 E100 F100 to extrude 100 mm slowly.
  5. Measure from the extruder entry to your mark. If 20 mm are left, the extruder is calibrated; enter the number here otherwise.
  6. Save the new value: M92 E… and M500 in Marlin, or edit rotation_distance and restart Klipper. Repeat once to confirm.

Typical values

Stock single-gear extruders on many budget printers start around 93 steps/mm; geared dual-drive extruders (e.g. BMG-style, 3:1) are around 400–420, and compact high-ratio extruders 600–700. Always calibrate – these are only starting points.

E-steps or flow rate?

E-steps make the extruder push the right length of filament. Flow (extrusion multiplier) in the slicer then fine-tunes how much plastic each line gets for a particular filament. Calibrate E-steps once per extruder, flow per filament.

Common questions

What if my extruder pushed more than 100 mm?

Then the distance left is less than 20 mm and the new E-steps will be lower than the current value. Enter the numbers as measured – the formula handles both directions.

Should I do this with the nozzle on?

Yes, at printing temperature. Some guides extrude with the hotend detached ("no resistance"), but measuring through the nozzle reflects real printing.

Klipper uses rotation_distance – what do I enter?

Enter your current rotation_distance in the optional field. The new value is old × actual ÷ requested (it moves in the opposite direction to E-steps).