Volumetric flow calculator

Find the fastest speed your hotend can melt plastic for. That number decides whether a fast print comes out strong or under-extruded.

Never uploadedmm³/sMax speedUnder-extrusion checkAny printer

Loading tool…
3dfiles Pro: big files, STEP export, batches.Pro adds files over 100 MB, unlimited STEP export, fit-to-printer cuts, colour 3MF and big batches. Free for 7 days, or a one-off 7-day pass.
See Pro

The formula

Volumetric flow (mm³/s) = layer height × line width × speed. A 0.2 mm layer with 0.45 mm lines at 100 mm/s needs 9 mm³/s of molten plastic. If that is more than the hotend can melt, the nozzle starts skipping – thin, weak or gappy layers.

Typical hotend limits

Hotend typeRough limit (PLA)
Standard short melt zone (V6-style, many stock hotends)≈ 10–15 mm³/s
Long or high-flow melt zones (Volcano-style, CHT nozzles, modern fast printers)≈ 20–35 mm³/s

These are rough ranges; the real limit depends on temperature, filament and nozzle. Measure yours with a max-flow test (OrcaSlicer: Calibration → Max flowrate) and use that number here. PETG and ABS usually allow less than PLA.

Using the result

  • Set the slicer's max volumetric speed (PrusaSlicer, OrcaSlicer and Bambu Studio have this setting) to about 90 % of your measured limit.
  • Thicker layers and wider lines need more flow, so they lower the maximum speed.
  • Outer walls are usually printed slower for looks – the limit matters most for infill.

Common questions

What is a good volumetric flow for PLA?

Most standard hotends handle 10–15 mm³/s reliably; high-flow hotends 20–35 mm³/s. Test yours – it is the only exact number.

Why does my fast print have weak layers?

The flow demand is above what the hotend can melt, so the plastic is not fully melted or not enough comes out. Lower speed, layer height or line width, or raise temperature slightly.