Hollow STL

Hollow a solid model for resin printing. Set the wall thickness, add drain holes, check the cut-away view and see how much resin it saves.

Never uploadedEven wall thicknessDrain holesResin saved in ml

Loading tool…
3dfiles Pro: big files, STEP export, batches.Pro adds files over 100 MB, unlimited STEP export, fit-to-printer cuts, colour 3MF and big batches. Free for 7 days, or a one-off 7-day pass.
See Pro

How to hollow an STL

  1. Drop the model into the box above. It has to be a closed solid; the tool tells you if it is not.
  2. Set the wall thickness. The inside is removed and the wall is left all the way round.
  3. Choose the number and diameter of the drain holes. They are cut through the bottom of the model, at the lowest points of the cavity.
  4. Look at the cut-away view, then download the hollow model. The download is the whole model; only the preview is cut open.

Wall thickness for resin printing

ModelWall
Miniatures and figures up to about 60 mm1.2 to 2 mm
Busts and display pieces, 60 to 150 mm2 to 3 mm
Large or functional parts, anything that is handled a lot3 mm or more

Thinner walls save more resin but can warp while curing and crack later, especially with brittle standard resins. If the model is thinner than twice the wall anywhere, that region simply stays solid.

Why drain holes matter

A closed hollow print traps liquid resin. It can leak months later through a hairline crack, and the cup-shaped cavity pulls on the film at every layer, which causes failed prints. Two holes are better than one: resin runs out of one while air enters through the other. Place the model in the slicer so the holes face the build plate side, wash the inside, and cure it with a small UV light before plugging the holes if you want them closed.

How the inside is made

The model is sampled on a fine grid, the distance from every inside point to the surface is measured, and the cavity is the surface that lies exactly one wall thickness inside. That gives an even wall on curved shapes, where simply scaling the model down would not. Sharp inner corners come out slightly rounded, which also helps the resin drain.

Common questions

Does hollowing change the outside of the model?

No. The outer surface is untouched; only the inside is removed and the drain holes are added.

Where are the drain holes placed?

In the bottom of the model as it sits in the file (lowest Z), under the lowest parts of the cavity and apart from each other. Rotate the model first with the STL editor if another side should face down.

Can I hollow a model for FDM printing?

There is rarely a reason to: a slicer already prints walls with sparse infill. Hollowing is for resin printing, where the slicer fills the model completely.

Why does it say the model is not watertight?

Hollowing needs a closed solid to tell inside from outside. Run the file through the STL repair tool first.

Is it free?

Yes – 2 downloads a day are free, with no sign-up or watermark. Pro (free for 7 days) makes it unlimited.

Is my file uploaded?

No. The file is processed in your browser and never leaves your device.