Vase generator

Shape a vase with a few numbers: height, widths, belly, ribs and twist. Download it solid for spiral vase mode, or with a wall for normal printing.

Never uploadedSpiral vase mode readyRibs and twistRound or polygonSTL & 3MF

Loading tool…
3dfiles Pro: big files, STEP export, batches.Pro adds files over 100 MB, unlimited STEP export, fit-to-printer cuts, colour 3MF and big batches. Free for 7 days, or a one-off 7-day pass.
See Pro

Examples

These pictures are this tool's own preview, not photographs. Click one to open the tool with those settings. Printed something with it? Send a photo to hello@3dfiles.app and it can be shown here.

How to design a vase

  1. Set the height and the bottom and top diameters.
  2. Belly widens the middle (or narrows it with a negative value); Belly height moves the widest point up or down.
  3. Add ribs for a fluted surface and twist to make them spiral. A polygon cross-section with twist gives the classic twisted low-poly vase.
  4. Choose how it will be printed and download.

Solid or with a wall?

Solid, for spiral vase mode is the usual choice. The file is a filled shape, and the slicer's vase mode ("Spiralize outer contour" in Cura, "Spiral vase" in PrusaSlicer, Bambu Studio and OrcaSlicer) prints only its outside as one continuous line, with a solid bottom. The wall is one line thick, the surface has no seam, and it prints fast.

With a wall and floor makes a real hollow vase in the file, for a thicker wall than one line or for printers and resins without a vase mode.

Will it hold water?

A single-wall vase printed in PLA usually seeps a little through the layer lines. For fresh flowers, print with a 0.6 mm or larger nozzle, raise the flow a few per cent, or seal the inside with clear varnish or epoxy. PETG is more watertight than PLA. For dried flowers none of this matters.

Shapes that print well

  • Keep the wall leaning out by less than about 45° from vertical. A very strong belly near the bottom overhangs too much for a single wall.
  • Twist looks best between 45° and 180° over the height; more than that turns ribs into steep overhangs.
  • A bottom at least 40 mm wide keeps a tall vase from tipping during the print.

Common questions

What is spiral vase mode?

A slicer setting that prints the outer wall as one continuous rising line instead of separate layers. The model must be solid; the slicer hollows it.

Which nozzle should I use?

A 0.4 mm nozzle works; 0.6 or 0.8 mm gives a stronger, more watertight single wall and prints faster.

Can I make a pot or a pen holder with it?

Yes. Use "With a wall and floor", set equal top and bottom diameters and no belly for a straight cylinder, or a polygon cross-section for a faceted pot.

Is it free?

Yes – 2 downloads a day are free, with no sign-up or watermark. Pro (free for 7 days) makes it unlimited.

Is my file uploaded?

No. The file is processed in your browser and never leaves your device.